Tools required.

• Stanley knife or Scissors
• Sealant gun ( not included in kit )
• Fugi Silicone profiler ( not included in kit )
• Kitchen roll.
• Methylated Spirits ( blue / purple liquid )

Shower Floor Seal 1m Installation Guide

NOTE Shower Floor Seal is designed to form a
physical barrier on the wet room floor, to help
keep the water in the desired area and not all
over your wet room floor.

Step 1. Clean the floor area you wish to fit to with Methylated
Spirits to remove any products such as shampoo or conditioner
from the floor.

Step 2. Remove the Shower Floor Seal from its packaging
and lay it on the wet room floor to decide on the size you need.

Step 3. Cut the profile to the correct size required – re lay it in
position on the wet room floor to check it fits properly.

Step 4. Silicone the back of the profile and lay in place on wet
room floor. Remove any surplus sealing with the fugi tool.

Step 5. Leave to set for a minimum of 5 hours before using
the wet room. Your installation is now complete.